Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Linux Based Receivers
Linux Receivers General
OB-S10 LNB input to Rx problem.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="althom40" data-source="post: 768628" data-attributes="member: 275353"><p>Had this problem for some months. With a direct cable input into the LNB input all channels OK.</p><p>Take a loop through to my TM5300D and only the lowest Tp ( C4 Film4 More4 ) signal breaks up.</p><p>Feeding both Rx's directly then there is no problem.</p><p>If I use a back-back connector with a very short lead into the S10 only the same Tp/channels are affected.</p><p>If I put my hand around the cable near the LNB-in then the picture breakup stops.</p><p>I have chopped a bit off my feed cable, remade connections, opened up the S10 and remade</p><p>the solder joints around the little LNB input circuit board and its still the same.</p><p>I am guessing that it is some kind of screening problem?</p></blockquote><p></p>
[QUOTE="althom40, post: 768628, member: 275353"] Had this problem for some months. With a direct cable input into the LNB input all channels OK. Take a loop through to my TM5300D and only the lowest Tp ( C4 Film4 More4 ) signal breaks up. Feeding both Rx's directly then there is no problem. If I use a back-back connector with a very short lead into the S10 only the same Tp/channels are affected. If I put my hand around the cable near the LNB-in then the picture breakup stops. I have chopped a bit off my feed cable, remade connections, opened up the S10 and remade the solder joints around the little LNB input circuit board and its still the same. I am guessing that it is some kind of screening problem? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Linux Based Receivers
Linux Receivers General
OB-S10 LNB input to Rx problem.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top