Found a work around late last night
I changed the OCS Lnb configuration to 09750/ 10750 now the polarizer is now active for the Analogue and Digital channels. To select between low band and high band I am using the 13/18-volt polarity switching to control between the low and high bands...
I don't wish to be funny
With the receiver, I have tried every configuration I can think of swapping all the setting everything the only conclusion I can thinks of is every analogue channel is in the High band when they need to be in the low band, and then I have changed the polarity's in case...
Thanks Lancelot for your reply
For some reason the wideband Lnb setting in the receiver won't work, this should be the correct setting for this Lnb all the options are available.
The universal setting works but I have to switch the polarity from 18 volts as this selects the High band...
Thanks RolfW for your reply
The Calamp is a Quad band 13volts for low band 18 volts for high band there no 13/18 for polarity switching or 20KHz tone switching for Low/High band.
Hope this Helps
Regards'O'-red
I have California Amplifier Wideband LNB and a Technomate Tm-5500Dapci the Lnb wide band setting won’t work for some reason only the universal setting will.
Changed the LNB setting to Lo High for 10750 and Lo lo to 09750 but the analogue signal is lost the universal setting works fine but the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.