Why don't installers like octoLNBs?

satelliteman

Administrator
Staff member
Joined
May 7, 2007
Messages
12,039
Reaction score
387
Points
83
My Satellite Setup
See signature
My Location
Northants, Midlands UK & Lanzarote, Canary Islands
Rubber weather boot and pull down cover... or f compression with o-ring and drop down cover is sufficient enough.
 

speculatrix

Regular Member
Joined
Jan 3, 2004
Messages
26
Reaction score
1
Points
3
Age
57
My Location
East Anglia, UK
********* recommends using silicon grease
Code:
http://www.*********.co.uk/tech/boots.htm   Fitting rubber boots to LNB cables
 
Last edited by a moderator:

rolfw

Believe it when I see it Admin.
Staff member
Joined
May 1, 1999
Messages
38,292
Reaction score
1,615
Points
113
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
********* recommends using silicon grease
That is in my opinion overkill, pull down rain shields, self amalgamating tape with decent quality F connectors correctly nipped up, provide more than adequate protection. Nowadays with compression connectors, "O" Rings and pull down rain shields, nothing else is required.

As an installer, I've removed many LNBs, whether due to failure or upgrading, and have only ever seen signs of water ingress where cheap and nasty screw connectors have been used with no rain cover or self amalgamating tape, or the crimp connectors were not tightened sufficiently.
 
Last edited by a moderator:

a33

Specialised Contributor
Joined
Sep 24, 2009
Messages
1,237
Reaction score
710
Points
113
Age
63
My Satellite Setup
XSAT410
Rebox RE-9000
My Location
NL
- all ports are stuck on vertical polarisation! The ports can switch band still.
I do wish it had stuck on H, because it means that FreeSat doesn't work properly.
So why not turn the lnb a quarter of a circle?
That way you can receive H-transponders (though you must fool your receiver that they are V).
:-)

Greetz,
A33
 

timo_w2s

Retired Mod
Joined
Sep 28, 2005
Messages
4,359
Reaction score
2,883
Points
113
Website
www.timo.me.uk
My Satellite Setup
See Signature
My Location
Maidenhead, UK & Helsinki, Finland
So why not turn the lnb a quarter of a circle?
That way you can receive H-transponders (though you must fool your receiver that they are V).
:-)

Greetz,
A33

But I don't think you can tell the Freesat box to reverse the polarities as the frequencies are downloaded from the EPG data. I suspect you could do it in non-Freesat mode but then you lose the benefit of the Freesat EPG again.
 

PaulR

Dazed and Confused Admin
Staff member
Joined
Jun 28, 2003
Messages
18,023
Reaction score
4,046
Points
113
My Satellite Setup
-----------See sig-----------
My Location
Wirral, NW UK and Vaucluse, France.
The box wouldn't "know" the LNB had been rotated; it would continue to send out the commands to the LNB which would ignore them. So Vs would become Hs and vice-versa. At which point the Freesat H channels would come flooding in.

It's only a temporary fix though. It really does need sorting properly. Are you sure that the LNB is really at fault? Perhaps the box can't supply a high enough voltage to switch to H, or the voltage is being lost somewhere along the line?
 

timo_w2s

Retired Mod
Joined
Sep 28, 2005
Messages
4,359
Reaction score
2,883
Points
113
Website
www.timo.me.uk
My Satellite Setup
See Signature
My Location
Maidenhead, UK & Helsinki, Finland
The box wouldn't "know" the LNB had been rotated; it would continue to send out the commands to the LNB which would ignore them. So Vs would become Hs and vice-versa. At which point the Freesat H channels would come flooding in.

Oh yes, of course it's stuck in one polarity. Sorry, it was too early in the morning for me. ;)
 

a33

Specialised Contributor
Joined
Sep 24, 2009
Messages
1,237
Reaction score
710
Points
113
Age
63
My Satellite Setup
XSAT410
Rebox RE-9000
My Location
NL
The box ... would continue to send out the commands to the LNB which would ignore them.
It's only a temporary fix though. It really does need sorting properly. ....

Ah yes, I (also) forgot that. You don't have to fool the receiver, as the LNB is fooling the receiver already ;) (assuming the LNB is indeed the cause). I hope you all (or some of you) will forgive me....

And of course a more permanent fix would be needed. But maybe the tempory disappointment of @speculatrix could be fixed a little :) .

Greetz,
A33
 

speculatrix

Regular Member
Joined
Jan 3, 2004
Messages
26
Reaction score
1
Points
3
Age
57
My Location
East Anglia, UK
At first I laughed at the idea of rotating the LNB, but then I realised it's a stroke of genius *and* madness.

A freesat receiver needs to see the home transponder when tuning it, otherwise it's a brick.

I don't know why it won't switch. I have two DVRs connected, neither of them can get their LNBs to switch. I have seen this problem before and it's gone away. In fact, a couple of ports on the octo LNB were problematic out of the box, but since I've only ever used five at most of the eight, I never got round to investigating it.
I've got a new LNB on its way, so I'll be cabling it up ready to install, then I can swap the old one out and the new one in. I've got a spare dish I can rest on a garden chair and fiddle with the old LNB to see if cleaning it up and using dry/fresh coax will fix it.
 

Channel Hopper

Suffering fools, so you don't have to.
Staff member
Joined
Jan 1, 2000
Messages
35,533
Reaction score
8,554
Points
113
Age
59
Website
www.sat-elite.uk
My Satellite Setup
A little less analogue, and a lot more crap.
My Location
UK
********* recommends using silicon grease
Code:
http://www.*********.co.uk/tech/boots.htm   Fitting rubber boots to LNB cables

Does anyobody sell silicon grease in the trade these days ?
(unless they have a shedload to get rid of ?)

Nothing wrong with Vaseline in the right conditions (oooerr missus)
 

Terryl

Specialist Contributor
Joined
Apr 14, 2011
Messages
3,246
Reaction score
1,932
Points
113
Age
82
My Satellite Setup
OpenBox X5 on a 1 meter motorized dish.
And now a 10 foot "C" band dish.

Custom built PC
My Location
Deep in the Boonies in the central Sierra Nevada mountains of California.
I like to use a dual output LNB (for a single satellite) then a multi-switch in a well protected area, less problems to go wrong with water intrusion into a loose connector.
 

Terryl

Specialist Contributor
Joined
Apr 14, 2011
Messages
3,246
Reaction score
1,932
Points
113
Age
82
My Satellite Setup
OpenBox X5 on a 1 meter motorized dish.
And now a 10 foot "C" band dish.

Custom built PC
My Location
Deep in the Boonies in the central Sierra Nevada mountains of California.
Does anyobody sell silicon grease in the trade these days ?
(unless they have a shedload to get rid of ?)

Nothing wrong with Vaseline in the right conditions (oooerr missus)
Don't use vaseline on coax connections it will rot the center insulation for the center conductor over time.

They make a special coax grease, I only use that.
 

speculatrix

Regular Member
Joined
Jan 3, 2004
Messages
26
Reaction score
1
Points
3
Age
57
My Location
East Anglia, UK
Does anyobody sell silicon grease in the trade these days ?

just search for Servisol grease. I found quite a few sellers on Amazon for under £5 for a decent sized tube. It can sit in the toolbox next to the syringe of thermal paste I bought that will last me a life time and probably be handed down through the generations!
 

Terryl

Specialist Contributor
Joined
Apr 14, 2011
Messages
3,246
Reaction score
1,932
Points
113
Age
82
My Satellite Setup
OpenBox X5 on a 1 meter motorized dish.
And now a 10 foot "C" band dish.

Custom built PC
My Location
Deep in the Boonies in the central Sierra Nevada mountains of California.
This is as close to the little tube of connection grease that Andrews antennas supplied with their heliax coax for over 50 years, used for all their outside coax to antenna connections.

Code:
http://www.summitsource.com/stuf-dielectric-waterproof-grease-filler-cross-devices-coaxial-connector-with-teflon-volume-tube-p-12378.html

It's all that I ever use, and the only coax grease I will recommend to anyone, I have been using this grease for over 40 years.

It doesn't migrate, melt in the heat, get hard, collect moisture or dissipate over time.
 

Lazarus

Retired Moderator
Joined
May 29, 2009
Messages
27,078
Reaction score
8,664
Points
113
My Satellite Setup
80cm Motorised.
Several small Dishes.
Much else.
My Location
North York Moors
It doesn't migrate, melt in the heat, get hard, collect moisture or dissipate over time.


That describes me perfectly :rolleyes::D
 

speculatrix

Regular Member
Joined
Jan 3, 2004
Messages
26
Reaction score
1
Points
3
Age
57
My Location
East Anglia, UK
Thanks, Terryl, I should have known that sort of stuff existed.
 

daro2096

Regular Member
Joined
Jan 21, 2009
Messages
451
Reaction score
48
Points
28
Age
49
My Satellite Setup
No setup at present
My Location
Consett, Durham
Got to agree with that, but just out of interest, what would you say is a ball-park figure for fitting an Octo and doing the three additional cable runs?

An installer charged me £60 to run an extra three cables to my Vu+ Duo 2 box. In my opinion I was ripped off but needed the extra cables in time for the election results coverage on several channels at once. If I had a ladder I would have done it myself as I live in a ground floor flat and the dish isn't that high up.
 

Lazarus

Retired Moderator
Joined
May 29, 2009
Messages
27,078
Reaction score
8,664
Points
113
My Satellite Setup
80cm Motorised.
Several small Dishes.
Much else.
My Location
North York Moors
Installers aren't charities!

However simple the task is, he/she still has fixed overheads, has to travel there and back, and then there's the cost of materials all before even considering the time actually spent on site.

Couldn't you have borrowed a ladder, though?

As for the Election, were the results not the same whichever Channel you watched? (Excluding Fox News, obviously)?
 
Top