RimaNTSS's latest activity
-
RimaNTSS replied to the thread EGIS motor.Not so long time ago I've got this LNB for PFA with mechanical polarizer. It changes H to Y by applying some DC voltage to the motor. -
-
yes thank you for allowing me to use this form and thank you for the advice
-
Hallo allemaal, Ik heb hier nog een oude Irte antenneschotel staan die ik wil opknappen, maar wat voor LNBF moet hier op de schotel...
-
RimaNTSS replied to the thread Advice Needed Irte dish.I would advise GI-209P And welcome to the Forum!
-
-
I had the opportunity to buy a 140 cm prime focus, I made an adaptation to mount it on the EGIS engine. The particularity of this...
-
thanks riman i have those lnb too , i m looking for wide band ku .
-
RimaNTSS replied to the thread EGIS motor.@dreambox1959 Are you interested in something like those?
-
-
RimaNTSS replied to the thread Bargain Second-Hand Big Dishes For Sale.Prodelins. Not bad.
-
RimaNTSS reacted to Big Al's post in the thread For Sale Jaeger Supermount 1224, Two Vu+ solo (White), Techomate 2600 super Diseq Hh motor with
Like.
Hi Guyz Im having a clear out I have the following for sale : Two x Vu+ solo (White) with remote & power lead (Used)- £60 each + £7... -
RimaNTSS reacted to hatters1976's post in the thread Best Lnb for 2.40 dish feeds low signal at Eutelsat 7 east ? with Like.
my equipment ...
-
RimaNTSS reacted to Channel Hopper's post in the thread I want measurements channel master 2.4m dish offset with Like.
Dimensions of the ones here on tape measure. The rx/tx support arms are a completely different length and have no end bolt
-
RimaNTSS reacted to nelson_b's post in the thread I want measurements channel master 2.4m dish offset with Like.
Best i can do with the arm in position ..... i also have subreflector arms currently stored in my garage .
-
RimaNTSS replied to the thread I want measurements channel master 2.4m dish offset.That is more than enough for me, thanks.
-
RimaNTSS replied to the thread I want measurements channel master 2.4m dish offset.I do not need precise, just rough size (+/- 5cm). Thanks
-
RimaNTSS reacted to nelson_b's post in the thread I want measurements channel master 2.4m dish offset with Like.
Didn,t try measuring the bottom one (more difficult- and it started raining ) will try and look later when the weather clears...
