jeallen01
Specialist Contributor
- Joined
- Oct 12, 2003
- Messages
- 6,674
- Reaction score
- 2,630
- Points
- 113
- My Satellite Setup
- See Signature
- My Location
- Somewhere in England (possibly?)!
Morning
A quick/hopefully easy (?) question:
I've got a couple of the above just laying around, and I wondered if it is possible to use only the LNB that is mounted directly on the feedarm, and thus treat it as if the other offset one just didn't exist - but without using the DiSEqC "A or B" selection command, i.e. if I didn't set the receiver to send that command, would one section of the LNB still work?
(obviously, a quick test would be required to determine which section would work, although if one is actually marked as "A" then that's probably the one that should work without any command, or at least that is what I would hope)
Thanks in advance.
A quick/hopefully easy (?) question:
I've got a couple of the above just laying around, and I wondered if it is possible to use only the LNB that is mounted directly on the feedarm, and thus treat it as if the other offset one just didn't exist - but without using the DiSEqC "A or B" selection command, i.e. if I didn't set the receiver to send that command, would one section of the LNB still work?
(obviously, a quick test would be required to determine which section would work, although if one is actually marked as "A" then that's probably the one that should work without any command, or at least that is what I would hope)
Thanks in advance.