mythbackend
Member
- Joined
- Jan 22, 2010
- Messages
- 4
- Reaction score
- 0
- Points
- 0
- Age
- 54
- My Satellite Setup
- 1m FTA dish. Coolsat 6000 and DM500s receiver.
- My Location
- Southeast, USA
Hi Everyone,
I am really stumped and wanted to see if anyone has any ideas.
I have a DM500 and it just refuses to pick up circular signals (linear works). I've bypassed my HH motor and a diseqc switch (for trouble shooting) and the problem persists. The SNR says 40 to 50 constantly. I know my problem is in the Dreambox though because I can hook up a Coolsat receiver and tune circular channels right in. The signal strength shows 97-99%. Why Why Why wont my DM pick them up?
My LNB is an Invacom QPH-301 (and yes using the circular connector). Firmware is Gemini, but the same problem existed with PliJade too.
I did notice that when I set the options for a single satellite, the LNB settings screen is not available - so I can't confirm what the LOF/H is set to. When I had the motor hooked up, I could confirm it was set to 11250 (I'm in NA).
Any thoughts? TIA!
I am really stumped and wanted to see if anyone has any ideas.
I have a DM500 and it just refuses to pick up circular signals (linear works). I've bypassed my HH motor and a diseqc switch (for trouble shooting) and the problem persists. The SNR says 40 to 50 constantly. I know my problem is in the Dreambox though because I can hook up a Coolsat receiver and tune circular channels right in. The signal strength shows 97-99%. Why Why Why wont my DM pick them up?
My LNB is an Invacom QPH-301 (and yes using the circular connector). Firmware is Gemini, but the same problem existed with PliJade too.
I did notice that when I set the options for a single satellite, the LNB settings screen is not available - so I can't confirm what the LOF/H is set to. When I had the motor hooked up, I could confirm it was set to 11250 (I'm in NA).
Any thoughts? TIA!