Reply to thread

Message: <blockquote data-quote="PaulR" data-source="post: 737533" data-attributes="member: 176256">I can't think of a better way than using a multiswitch.CT125 would be overkill for internal runs - you only need CT100 (or WF100).  An extra amplifier won't be needed - the multiswitch should supplu enough signal.  Try to get a multiswitch which offers different levels of signal output on some of the outputs.Don't forget that the 28E needs to be on DiSeqC 1 (or A) as $ly boxes expect to "see" only 28E.If you're using separate receivers for the non 28E positions then you'll need a separate feed to the one which will be used for a dedicated 28E receiver..  So that means an extra cable to these positions.</blockquote>