Reply to thread

Message: <blockquote data-quote="jeallen01" data-source="post: 1121670" data-attributes="member: 176704">My centauri 16/1 is on the end of 25-30m of WF100 cable (+ up to 8m of cables to  the LNBs themselves) and there's also a Smart Priority Switch (and an antenna relay in the case of the SX88+ in the Lounge!) in the path and that combo works fine.The only downside is that the F-sockets on the switch are quite close together and that makes it quite difficult to tighten up the plugs and then seal them - so I use a small 11mm open-ended spanner with the sides ground down, and then coat all the connectors with a spray-on rubberised sealant (much easier and remove than trying to fit self-amalgamating tape or rubber boots) before I slide the switch into the cover.</blockquote>