Anixe HD and Astra HD at 19.2E

[icarusi]

Can anyone here receiving these channels get the P or P+ to show these channels from standby. The only way I can get them to show correctly is to go via an SD channel. Still sometimes getting lockups requiring a hard start, if I use the channel up/down buttons or list selection rather than the numberpad. Ditto with HD channels on 28.2 shortly after switch-on.

 

[howardbowell]

Yes, have found exactly the same problem.

Have you edited the channel list via computer? I have and believe this to be the problem.

If you do a factory re set and use the standard settings every HD channel will work. Very strange!

 

[icarusi]

Yes, have found exactly the same problem.

Have you edited the channel list via computer? I have and believe this to be the problem.

No, just the standard scan from the P+.

If you do a factory re set and use the standard settings every HD channel will work. Very strange!

I wonder if the preset pids or symbol rates are a bit off, or something? I'll have a double check with Lyngsat. Radio on 28.2 is similarly iffy from startup. I need to go to TV and back or from standby to get a signal.

OTOH my LNB may be slightly off frequency which wouldn't help matters.

 

[howardbowell]

Use channel editor version 1.01, and problem is solved. Try it!

Also upgrade pox to the latest firmware, available from the fortec website.