Reply to thread

Message: <blockquote data-quote="John" data-source="post: 990771" data-attributes="member: 175005">1./ Your servo wiring is correct Dave.2./ Re: flick switch,  you need to use this in both positions to get the full 180 deg travel from the servo motor.    Used only if your going to make the Zinwell do Hor & Ver  as well as L & R polarisation. See pic.3./ Added labels:  Yep, added by me.  Done after i had calibrated the APC to correspond with the polarity positions of the feed..... which when added were actually on another Cband feed system & not the                      Zinwell.  Trimming of the servo travel can be fine tuned by the small trim pots on the side.Btw .... hooked the RC2KX up to the 1.8 earlier on, set the limits etc and looking ok.  Silent in operation, like the Fast/Slow function. Need to program it up a bit when iv'e got a bit more time.</blockquote>