Reply to thread

Message

<blockquote data-quote="moonbase" data-source="post: 990779" data-attributes="member: 178786">John,I wired up the servo to the APC as confirmed and tried it out, its working but I am not sure if I am balancing the Invert/Normal switch correctly with the Skew rotation. I marked the Servo wheel that fixes to the Zinwell at the 12 o'clock position and no matter what combination of the Invert/Normal switch and the Skew rotator dial I only get 90 degrees travel anti clockwise and back. Is this adjustable via the small trip pots on the side of the APC?When I come to setup the AV-COMM barrel with the Zinwell and the Servo I will be using in on linear H and V signals initially. Could you please tell me how I orientate the AV-COMM barrel with respect to the internal steps for linear H and V polarities and the internal probes on the Zinwell? If I can get it setup close to the theoretical orientation then the 90 degree rotation scope I have from the servo might be enough?Thx</blockquote>

[QUOTE="moonbase, post: 990779, member: 178786"] John, I wired up the servo to the APC as confirmed and tried it out, its working but I am not sure if I am balancing the Invert/Normal switch correctly with the Skew rotation. I marked the Servo wheel that fixes to the Zinwell at the 12 o'clock position and no matter what combination of the Invert/Normal switch and the Skew rotator dial I only get 90 degrees travel anti clockwise and back. Is this adjustable via the small trip pots on the side of the APC? When I come to setup the AV-COMM barrel with the Zinwell and the Servo I will be using in on linear H and V signals initially. Could you please tell me how I orientate the AV-COMM barrel with respect to the internal steps for linear H and V polarities and the internal probes on the Zinwell? If I can get it setup close to the theoretical orientation then the 90 degree rotation scope I have from the servo might be enough? Thx [/QUOTE]

Verification