Reply to thread

Message: <blockquote data-quote="Channel Hopper" data-source="post: 1106101" data-attributes="member: 175144">From memory, (I'm going on the roof to check important dimensions as it is raining, again) the lower part of the bearing 'C' cage can be drilled with a hole further forward, with the bearing bolt inserted accordingly (perhaps with some metalwork shaved from the rectangular base corners to allow full arc movement), an offset closer to that of the Channel Master design should be possible.No guarantee it is going to be fully compatible (and a 'V' wedge may still be required), but the reflector mass will be closer to the bearings and the quality of the IRTE polarmount will keep everything shipshape for near perpetuity.</blockquote>