Reply to thread

Message

<blockquote data-quote="John" data-source="post: 1127442" data-attributes="member: 175005">Just a few more pics of the lightweight version of the motorised Ku feed for the CM roof mounted dish for anybody interested in knocking up home brew stuff .... Mostly all the bits used are salvaged from the metal scrap bits and bobs or stuff iv'e collected over the years and re-used them.Waiting for the wire wound 'feed position' indicator pot to arrive and fix onto the main scalar cog.The&nbsp; 0 - 22Khz switch was an exact fit onto the SMW pll lnb - bonus.The 12v drive motor ended up on top of the support rail.** Youtube vid to follow showing initial dish edge tracking...................................................................................................................................................................................................................................................................................................................................[ATTACH=full]141453[/ATTACH][ATTACH=full]141454[/ATTACH][ATTACH=full]141455[/ATTACH][ATTACH=full]141456[/ATTACH][ATTACH=full]141459[/ATTACH]The illustration showing illumination pattern shows what i was getting on my CM dishes before and after re-locating the lnb position............................................................................................................................................................................................................................................................................................................................................</blockquote>

[QUOTE="John, post: 1127442, member: 175005"] Just a few more pics of the lightweight version of the motorised Ku feed for the CM roof mounted dish for anybody interested in knocking up home brew stuff .... Mostly all the bits used are salvaged from the metal scrap bits and bobs or stuff iv'e collected over the years and re-used them. Waiting for the wire wound 'feed position' indicator pot to arrive and fix onto the main scalar cog. The 0 - 22Khz switch was an exact fit onto the SMW pll lnb - bonus. The 12v drive motor ended up on top of the support rail. ** Youtube vid to follow showing initial dish edge tracking. .................................................................................................................................................................................................................................................................................................................................. [ATTACH type="full"]141453[/ATTACH][ATTACH type="full"]141454[/ATTACH][ATTACH type="full"]141455[/ATTACH][ATTACH type="full"]141456[/ATTACH][ATTACH type="full"]141459[/ATTACH] The illustration showing illumination pattern shows what i was getting on my CM dishes before and after re-locating the lnb position. ........................................................................................................................................................................................................................................................................................................................................... [/QUOTE]

Verification