Convert from 36 volt motor to diseqc motor

[MrDish1]

is it possible to convert a 36volt motor to diseqc

Best regards

 

[Channel Hopper]

is it possible to convert a 36volt motor to diseqc

Best regards

The current requirements of a normal 36V actuator (and the dish they are moving) would probably prevent it .

I have few DiSeqC linear actuators, but they are for small reflector systems only.

You can convert a DiSEqC receiver up to a 36V outdoor unit if your motor is still seviceable.

 

[MrDish1]

I have a SMR 1224 H2H.
oke it is 12 Volt ,but can i make is to diseqc.

Mvg

 

[7mdish]

Use a vbox or a positioner from dreambox1959.

 

[Trust]

I have a SMR 1224 H2H.
oke it is 12 Volt ,but can i make is to diseqc.

Mvg

is it possible to convert a 36volt motor to diseqc

Best regards

Just Sharing This - Jaeger SMR1224 Usals ready

Today did some work to modify my SMR 1224 for the use with Usals . First removed the reedswitch en replaced the magnet wheel for one slot wheel . Put the optical sensor board at the right place , there is plenty of room in there . Set the limit switches to 80º E and 75 W making a 155º turn...

www.satellites.co.uk

 

[MrDish1]

are the diseqc PCBs from such a diseqc motor also freely available on the market?
otherwise I have to order it from Wim (Trust)

Mvg

 

[Trust]

I dismanteled all my diseqc rotors for those pcb’s . Not a single left

 

[Channel Hopper]

I dismanteled all my diseqc rotors for those pcb’s . Not a single left

I have a few of them, they may be a different model though. Will check the board/chip firmware numbers tomorrow.

 

[MrDish1]

I thought ; then I don't have to pull or lay so much power cable to run the motor(s) of the dishes.

 

[Terryl]

With a standard 36 volt linear motor for a satellite dish your still going to have to use one set of wires for the DC power and one set of wires for the control signals from any "V" box or control box your going to use.

Also your working with a DC voltage, the longer the run out to the dish for the power, the bigger the wire gauge needs to be, this to compensate for voltage loss or drop in the wire due to the amperage required by the motor. Use to thin a wire gauge and you may or will have problems.

 

[MrDish1]

I know

 

[Channel Hopper]

I have a few of them, they may be a different model though. Will check the board/chip firmware numbers tomorrow.

Apologies for the delay in replying, this is the circuit board I have a few of.

I can post out at postal cost if they are of any use.

 

[MrDish1]

Excuses voor de vertraging bij het beantwoorden, dit is de printplaat waar ik er een paar van heb.

Ik kan verzenden tegen verzendkosten als ze van enig nut zijn.

Super goed
Dank je

 

[Trust]

If they are no use to Mr Dish I like to have them

 

[Channel Hopper]

If they are no use to Mr Dish I like to have them

I have a few, probaby 30 or so.

 

[Trust]

Great , If it’s no problem I like to have 5

 

[Channel Hopper]

Great , If it’s no problem I like to have 5

I'll pull out the boxes later in the week and grade from good to not so good. I remember some had the connectors removed since they were used on other projects.

 

[MrDish1]

Oke.