You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
digitalb card initilizing
- Thread starter taff2412
- Start date
- Joined
- Dec 10, 2004
- Messages
- 6,051
- Reaction score
- 931
- Points
- 113
- My Satellite Setup
- 1.2M Channel Master, 1224 motor, VU+ Duo 2
- My Location
- North West
The DigitAlb card requires a Conax cam, or a Cam, patch or receiver capable of emulating a Conax Cam, check your receivers manual, contact your supplier, or check with other owners to see if your receiver is able to do this.
If your receiver is capable of emulating a conax cam then the card might not be activated, have you left it on the designated channel to receive the over the air activation?
Check with your cards supplier that they have actually requested activation of the card.
If your receiver is capable of emulating a conax cam then the card might not be activated, have you left it on the designated channel to receive the over the air activation?
Check with your cards supplier that they have actually requested activation of the card.
dave branson
Regular Member
- Joined
- May 28, 2003
- Messages
- 316
- Reaction score
- 0
- Points
- 0
- Age
- 82
- My Location
- Florence Italy
I have been having a similar problem,using a SAB explorer box,in the card slot, I put the card in upside down, and hi presto it then read CONEX card.
I then had another problem as all the channels where scambled,I contacted the supplier today who says they are going to re-initialise the card, itseems these cards switch off, if you do not leave them on all the time.
I then had another problem as all the channels where scambled,I contacted the supplier today who says they are going to re-initialise the card, itseems these cards switch off, if you do not leave them on all the time.