Reply to thread

Message

<blockquote data-quote="Jaska-oz" data-source="post: 991871" data-attributes="member: 409345">Hi thanks did not thick about that one.&quot;You can also try manually storing each satellite, by selecting No, to Usals, and saving it separately.e.g. Astra 1, 19.2E at position 1.You then manually drive the dish, to 19.2E, using the Positioner Setup options, get the strongest signal quality, and save it at position 1.You can then do the same for all the other satellites, e.g. 16E position 2, 13E position 3, 10E position 4, 9E position 5, 7E position 6, 5E position 7, 0.8W position 8, etc, then use positioner setup to drive your dish, to each satellite, and save them to the corresponding position.&quot;I just did that for the fixed dish on 28.2.&nbsp; I will give it a go soon and store them that way.Tuner B is removed from the setup when I started to try this so It didn't give me errors.&nbsp; But tuner B only has fixed dishes no motor.The 9/1 diseqc was tried to replace the 4/1 diseqc just in case of issues with the diseqc So the drawings was the two alternatives that I tried for the motor setup.&nbsp;Thank youJason</blockquote>

[QUOTE="Jaska-oz, post: 991871, member: 409345"] Hi thanks did not thick about that one. "You can also try manually storing each satellite, by selecting No, to Usals, and saving it separately. e.g. Astra 1, 19.2E at position 1. You then manually drive the dish, to 19.2E, using the Positioner Setup options, get the strongest signal quality, and save it at position 1. You can then do the same for all the other satellites, e.g. 16E position 2, 13E position 3, 10E position 4, 9E position 5, 7E position 6, 5E position 7, 0.8W position 8, etc, then use positioner setup to drive your dish, to each satellite, and save them to the corresponding position." I just did that for the fixed dish on 28.2. I will give it a go soon and store them that way. Tuner B is removed from the setup when I started to try this so It didn't give me errors. But tuner B only has fixed dishes no motor. The 9/1 diseqc was tried to replace the 4/1 diseqc just in case of issues with the diseqc So the drawings was the two alternatives that I tried for the motor setup. Thank you Jason [/QUOTE]

Verification