Reply to thread

Message

<blockquote data-quote="Archive4" data-source="post: 992030">OK, been to the shed and found a 4 way diseqc switch, slippery little sod, too me over half an hour to find one!Reconfigured my box using tuner A. ( locked it on tuner a in software )Set the config to Advanced and selected &quot; all satellites 1 ( usals ) and saved that. Then stepped through to 28.2 and changed the lnb to lnb2 and swapped the &quot; use USALS for this sat &quot; to no. Changed diseqc 1.1 command to port B. Saved that.Works fine switching from sat to sat via the motor. Also works ok when switching to 28.2 and goes to diseqc 2 as requested.BUT, when switching back to motor ( usals ) get a blank screen and no signal. However, put the box in standby for ten seconds and switch back on, hey presto! Signal is back to normal. Could be a glitch in the OpenVix software? Will have another play using the Selecting satellites 1 ( Usals ) option, after Strictly Come Dancing ( If I muck about during that I´ll never make another post )[USER=409345]@Jaska-oz[/USER] , try the same on your set up.Tuner A only, motor on port a (1) fixed dish on port b (2)</blockquote>

[QUOTE="Archive4, post: 992030"] OK, been to the shed and found a 4 way diseqc switch, slippery little sod, too me over half an hour to find one! Reconfigured my box using tuner A. ( locked it on tuner a in software ) Set the config to Advanced and selected " all satellites 1 ( usals ) and saved that. Then stepped through to 28.2 and changed the lnb to lnb2 and swapped the " use USALS for this sat " to no. Changed diseqc 1.1 command to port B. Saved that. Works fine switching from sat to sat via the motor. Also works ok when switching to 28.2 and goes to diseqc 2 as requested. BUT, when switching back to motor ( usals ) get a blank screen and no signal. However, put the box in standby for ten seconds and switch back on, hey presto! Signal is back to normal. Could be a glitch in the OpenVix software? Will have another play using the Selecting satellites 1 ( Usals ) option, after Strictly Come Dancing ( If I muck about during that I´ll never make another post ) [USER=409345]@Jaska-oz[/USER] , try the same on your set up. Tuner A only, motor on port a (1) fixed dish on port b (2) [/QUOTE]

Verification