Reply to thread

Message

<blockquote data-quote="jackpeas" data-source="post: 5295"><p>HI all, We tried again may31. Warren and I check the feed and found that the support for scalar ring 37''from backside to the center of the dish. I found that 1of the 3 bolts hold the scalar ring to the support(kinda look like a horse shoe,and it fit on the back of the feed) I had to grind some so the hole could line up.This is where the (allen) screw for tighten the feed.I used a yard stick and cut pvc 1 1/2 pipe to the 36''long. Here is the problem.The scalar ring is about 1'' thick. And the 36''pipe keep the feed center in the scalar ring.Now I am pass the 42 line on side of the feed. Now here where I tire my other feed(ADL non adjustable feed&nbsp; the one with the big scalar ring or housing) So I had to change out the lnb c-band,Iwill change out the ku lnb later. I also a ADL c/ku feed with adjustable scalar ring plus adl 2c&amp;2ku feed. 2 c/ku coroto feed. and Dual c(2c lnb for c-band in a seal unit) it still work. After all of this I am at the same spot.What my next move Idont know.On this dish there is some back support that help the dish keep it shape. They are 37'' long and about 6'' thread. We adjusted these, finger tight. We was thinking it may be out of round or something. I have look in the yellow pages a sat-repairman. All you find small dish repairman. Thank again Jackp n chicago</p></blockquote><p></p>

[QUOTE="jackpeas, post: 5295"] HI all, We tried again may31. Warren and I check the feed and found that the support for scalar ring 37''from backside to the center of the dish. I found that 1of the 3 bolts hold the scalar ring to the support(kinda look like a horse shoe,and it fit on the back of the feed) I had to grind some so the hole could line up.This is where the (allen) screw for tighten the feed.I used a yard stick and cut pvc 1 1/2 pipe to the 36''long. Here is the problem.The scalar ring is about 1'' thick. And the 36''pipe keep the feed center in the scalar ring.Now I am pass the 42 line on side of the feed. Now here where I tire my other feed(ADL non adjustable feed the one with the big scalar ring or housing) So I had to change out the lnb c-band,Iwill change out the ku lnb later. I also a ADL c/ku feed with adjustable scalar ring plus adl 2c&2ku feed. 2 c/ku coroto feed. and Dual c(2c lnb for c-band in a seal unit) it still work. After all of this I am at the same spot.What my next move Idont know.On this dish there is some back support that help the dish keep it shape. They are 37'' long and about 6'' thread. We adjusted these, finger tight. We was thinking it may be out of round or something. I have look in the yellow pages a sat-repairman. All you find small dish repairman. Thank again Jackp n chicago [/QUOTE]

Verification