Reply to thread

Message

<blockquote data-quote="jackpeas" data-source="post: 5361"><p>HI OLD SAT, Yes my ku have the same problem. I dont know what to do. To change back to my ADL 1c&amp; 1ku feed, I need to get the feed straighten out. Mean while I will be thinking on the 5'' pipe by 20'ft 5ft in the ground,15 ft in the air to clear the roof with the HH mount(I wiil give you the roof height, and you can tell me how much more I need to clear) HH drop down when its going west so It would not hit my roof(I dont know how much drop down their is.)I will have to dig another hole,I will have buy the HH mount,end cap. I will drive up there and pick it up. Did I tell you that drove up to skyvision, Fergus,MN.That about 700 or 800 mile from me.I wanted to buy a dish and I did like what they had. I think it was a UNImesh dish with the spincanation Now it time to think about how much this will cost. I think you said the HH mount cost over $300 buck( I hear that this mount is not as good as the old one&lt;(quality wise) weak. I would like to get one just about as good as the old(AJACK 180 HH mount) that a mount.Wont the 5'' cap add weight? If you tell me this is going to work I will do it( I am talking about making it easy to align the dish) and to installed.I will have to go online and fine out the cost.Tell me how deep I need to&nbsp; dig the hole, how much pole to put in the ground? How big of hole? How much Cement(bags)? I know I will have to weld something to the bottom to keep it from turnning ok.Now let work on getting the feed on right.So only change the feed on amc-k3@87 deg.What else I need to know? ok Thank you jackp n Chicago</p></blockquote><p></p>

[QUOTE="jackpeas, post: 5361"] HI OLD SAT, Yes my ku have the same problem. I dont know what to do. To change back to my ADL 1c& 1ku feed, I need to get the feed straighten out. Mean while I will be thinking on the 5'' pipe by 20'ft 5ft in the ground,15 ft in the air to clear the roof with the HH mount(I wiil give you the roof height, and you can tell me how much more I need to clear) HH drop down when its going west so It would not hit my roof(I dont know how much drop down their is.)I will have to dig another hole,I will have buy the HH mount,end cap. I will drive up there and pick it up. Did I tell you that drove up to skyvision, Fergus,MN.That about 700 or 800 mile from me.I wanted to buy a dish and I did like what they had. I think it was a UNImesh dish with the spincanation Now it time to think about how much this will cost. I think you said the HH mount cost over $300 buck( I hear that this mount is not as good as the old one<(quality wise) weak. I would like to get one just about as good as the old(AJACK 180 HH mount) that a mount.Wont the 5'' cap add weight? If you tell me this is going to work I will do it( I am talking about making it easy to align the dish) and to installed.I will have to go online and fine out the cost.Tell me how deep I need to dig the hole, how much pole to put in the ground? How big of hole? How much Cement(bags)? I know I will have to weld something to the bottom to keep it from turnning ok.Now let work on getting the feed on right.So only change the feed on amc-k3@87 deg.What else I need to know? ok Thank you jackp n Chicago [/QUOTE]

Verification