Reply to thread

Message: <blockquote data-quote="jackpeas" data-source="post: 5395"><p>HI OLD SATELLITE, some of the guys at the 4dtv forum(Delphi) think my 36" arm is bent.I don't think so. That a big arm, over 2" round and strong.How can I tell? Maybe I don't know.Remember the declination (31 turn on the declination rod for that 6.5,this lift the dish up and put more weight on the arm) You remember the 48'' ring(4 stud bolts and about 6'' of stud) Top2 is where we adjust them. The bottom 2 no adjusting(they are about 2'' from the ring, all the stud are doublenutts) On the L beam(elevation) Not the top part where you  put your angle finder.But where the center of dish the go(lot room between the dish and the box beam. I will take picture. Its seem to be heavy(but I move it al the time when change actuator) And there is hope yet. I will check it more closer to see if anything bent. Thank  jackp n chicago</p></blockquote><p></p>