Reply to thread

Message

<blockquote data-quote="jackpeas" data-source="post: 5399"><p>Dear Old Satellite,Yes I have a coroto feed on my dish at this time.I also Adl 2c &amp;2ku feed. This is 3rd dish I have Installed,1 radio shack(8.5 H H dish came with 2014 receiver) 2 wineguard 10 ft quarstar( my best dish, which I still have. Now DH Satellite 10 ft. My dish is on a 15ft pole/5ft in the ground.I have to used 8ft step ladder to change the feed.Here what I do,I take a small tv out to dish.I got a cable coming from the receiver connected to the tv out to the dish. Now I move my dish to AMC3(k3)tp600 digital(pbs) signal 100 quality 99.Here where I used my angle finder to adjust the elevation to 41.5. There is a 48'' ring with 4 weld studs bolts.(this is for declination)The 2top studs is the one that move the dish foward (some say 5.74 and other say 6.30) I used the 6.3 something but they pop in. I almost used all of the 6''stud up but I could not get the other sat. (I was told you only these nuts a little but I move them 31 turn) After not getting it to track the arc&nbsp; and it was late. I turn 31 time back where I started from. I will try again But if it dont work I wil put my wineguard back up. It already aligned.Yes I getting sat but it not align. I am losing my digital. AMC7 w7 fox come in good. thank you jackp n chicago</p></blockquote><p></p>

[QUOTE="jackpeas, post: 5399"] Dear Old Satellite,Yes I have a coroto feed on my dish at this time.I also Adl 2c &2ku feed. This is 3rd dish I have Installed,1 radio shack(8.5 H H dish came with 2014 receiver) 2 wineguard 10 ft quarstar( my best dish, which I still have. Now DH Satellite 10 ft. My dish is on a 15ft pole/5ft in the ground.I have to used 8ft step ladder to change the feed.Here what I do,I take a small tv out to dish.I got a cable coming from the receiver connected to the tv out to the dish. Now I move my dish to AMC3(k3)tp600 digital(pbs) signal 100 quality 99.Here where I used my angle finder to adjust the elevation to 41.5. There is a 48'' ring with 4 weld studs bolts.(this is for declination)The 2top studs is the one that move the dish foward (some say 5.74 and other say 6.30) I used the 6.3 something but they pop in. I almost used all of the 6''stud up but I could not get the other sat. (I was told you only these nuts a little but I move them 31 turn) After not getting it to track the arc and it was late. I turn 31 time back where I started from. I will try again But if it dont work I wil put my wineguard back up. It already aligned.Yes I getting sat but it not align. I am losing my digital. AMC7 w7 fox come in good. thank you jackp n chicago [/QUOTE]

Verification