Reply to thread

Message

<blockquote data-quote="Mickha" data-source="post: 627028" data-attributes="member: 187442">The Sim card is more than likely an old Access 9 mature content card, they were supplied free, at one time, when you bought a Dragon Cam.To program a Dragon Cam with the Cas 3 you need to use the Dummy Card, the oblong circuit board that connects to your Cas 3 using the 20 pin ribbon cable, you then insert your Dragon Cam, into the Cas 3, and insert the Dummy card into the Dragon Cam, with the &quot;Cas Inerface Dummy Card&quot; text facing upwards.You then start up the CAS studio 8.6c software, click on the Cam Module tab, and the Dragon Cam icons, ensure the version is set to 3.x-4.x.Your Cam can only take Predator software, so download any version of Predator 369, the last one produced, and place predator369.dra on your computer desktop, it makes it easier to navigate to.Click on the little icon, with 3 dots, at the end of the File Name address bar and navigate to predator369.dra, on your computer desktop.Click open and Start Update.Have you tried your Cam in your receiver?If it was bought second hand it might already have Predator 369 loaded on it, try inserting it into your receiver and navigating to the Cam menu, or insert your Dragon Cam in your Cas 3, start up the CIS 8.6c software, click on the Utilities tab and the Common Interface Host icon, this should be able to read your Cam.</blockquote>

[QUOTE="Mickha, post: 627028, member: 187442"] The Sim card is more than likely an old Access 9 mature content card, they were supplied free, at one time, when you bought a Dragon Cam. To program a Dragon Cam with the Cas 3 you need to use the Dummy Card, the oblong circuit board that connects to your Cas 3 using the 20 pin ribbon cable, you then insert your Dragon Cam, into the Cas 3, and insert the Dummy card into the Dragon Cam, with the "Cas Inerface Dummy Card" text facing upwards. You then start up the CAS studio 8.6c software, click on the Cam Module tab, and the Dragon Cam icons, ensure the version is set to 3.x-4.x. Your Cam can only take Predator software, so download any version of Predator 369, the last one produced, and place predator369.dra on your computer desktop, it makes it easier to navigate to. Click on the little icon, with 3 dots, at the end of the File Name address bar and navigate to predator369.dra, on your computer desktop. Click open and Start Update. Have you tried your Cam in your receiver? If it was bought second hand it might already have Predator 369 loaded on it, try inserting it into your receiver and navigating to the Cam menu, or insert your Dragon Cam in your Cas 3, start up the CIS 8.6c software, click on the Utilities tab and the Common Interface Host icon, this should be able to read your Cam. [/QUOTE]

Verification