Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Egis robot and a new control unit
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Hugocz" data-source="post: 1129187" data-attributes="member: 415382"><p>Hi, I have completed the revised HW version 2.0 design.</p><p>Compared to the original version of HW version 1.0, the following design changes:</p><p>1. The motor power switching relay has been replaced by an electronic version with an L6203 circuit</p><p>2. The control of the third DC motor was added</p><p>3. The reading of information from possible sensors of the third engine has been added</p><p>4. The control of two servomotors was added</p><p>5. The possibility of connecting the positioner and motors with cables at least 10 m long was tested</p><p>6. SPI and I2C signals were output from the RPI connector to separate terminals</p><p>I now design a printed circuit board for the mentioned HW. I am considering the possibility of two different designs. Firstly, the classic version of jumpers produced by etching. But also a version of the dividing lines, which can be produced by milling on a CNC milling machine.</p></blockquote><p></p>
[QUOTE="Hugocz, post: 1129187, member: 415382"] Hi, I have completed the revised HW version 2.0 design. Compared to the original version of HW version 1.0, the following design changes: 1. The motor power switching relay has been replaced by an electronic version with an L6203 circuit 2. The control of the third DC motor was added 3. The reading of information from possible sensors of the third engine has been added 4. The control of two servomotors was added 5. The possibility of connecting the positioner and motors with cables at least 10 m long was tested 6. SPI and I2C signals were output from the RPI connector to separate terminals I now design a printed circuit board for the mentioned HW. I am considering the possibility of two different designs. Firstly, the classic version of jumpers produced by etching. But also a version of the dividing lines, which can be produced by milling on a CNC milling machine. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Egis robot and a new control unit
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top