help with 2 problems plz

[noddy_2004]

hi all first problem i have it that i cant update my dragon cam as the dragon loader card and my fun7 card say the the location can not be verified i`m using infinity usb prog the two cards i have are 1:dragon loader card which has f84a printed on it 2: prussian5 fun7 card with both cards i have downloaded the repair file but still no joy the 2nd problem i have is i cant update my matrix reborn cam on my laptop (hp pavilion ze4900 o/s xp home sp2) i can install to dvb ca module but it comes up as code 10 this device cannot start any help will be appriciated thanks

 

[Mickha]

Hi noddy_2004,
which file are you trying to load onto your Dragon Cam, as there's not a lot left open.
To load your cards:
PIC F84a,
Start your programmer, insert your card, chip face down.
From the drop down box choose DragonloaderCard (PIC)
Leave the built in loader, and load predator343.dra into ext EEp, choose 2 reverse span and write.
For Fun Card 7,
Start your programmer, insert your card, chip face down.
From the drop down box choose DragonloaderCard (AVR)
Leave the built in loader, and load predator343.bin into ext EEp, choose 2 reverse span and write. or
Choose PrussianCard5
Load FUN7LDR into flash
load predator343.bin into ext EEp, choose 2 reverse span and write.
After your card has finished writing follow the instructions for updating your Cams firmware:
Turn on your receiver and ensure it's on a FTA channel.
Turn off your receiver.
Insert your loader card into your Cam, chip face up, and if not already insert your cam into the receiver.
Turn on your receiver.
Navigate to the cam menu and choose to load the dragon.
After loading is completed follow the instruction to remove your card and switch off your receiver.
Turn on your receiver.
In the menu you should now see Predator 343.
If you have followed these rules and it's still not loading please post back.
Best wishes
Mickha

 

[noddy_2004]

done that and it says error could not verify location
it says that when i try the fun card as well

i have 3 fun4 cards can i use them to program the dragon and just write the cards as i need them to update the cam or does it look like i need a new loader card thanks

 

[Mickha]

Hi noddy_2004,
you can only use a Fun Card 7, a dragon PIC loader card or a Cas to program a Dragon Cam, if both cards are failing has the Dragon Cam been loaded before?
You could always try repairing the cards via the following methods:
Fun Card 7,
Start your Infinity
Choose Prussian card 5
load FUN7LDR into flash and write.
then write to the card as normal.
PIC card
Start your Infinity
Choose DragonloaderCard (PIC)
write
then load ,dra and write as normal.
Follow the previous instructions for loading your Dragon Cam.
What receiver are you using with your Dragon?

 

[noddy_2004]

ive tryed repairing the cards but get the same error the dragon cam has been updated by myself 5 or 6 time last update was at xmas as have not had the time to do it and now i`ve lost all chanels the box is a echostar if you dont mine helping out i can sented you my loader card to see if you have any joy with it if not can you suggest a good place to get a replacement card from i`m in chichester west sussex if that help i dont know if you can sent pm`s on here if so pm me and i`ll sent you some contact details thanks for all you help so far