Reply to thread

Message

<blockquote data-quote="Mickha" data-source="post: 224601" data-attributes="member: 187442">Hi noddy_2004,which file are you trying to load onto your Dragon Cam, as there's not a lot left open.To load your cards:PIC F84a,Start your programmer, insert your card, chip face down.From the drop down box choose DragonloaderCard (PIC)Leave the built in loader, and load predator343.dra into ext EEp, choose 2 reverse span and write.For Fun Card 7,Start your programmer, insert your card, chip face down.From the drop down box choose DragonloaderCard (AVR)Leave the built in loader, and load predator343.bin into ext EEp, choose 2 reverse span and write. orChoose PrussianCard5Load FUN7LDR into flashload predator343.bin into ext EEp, choose 2 reverse span and write.After your card has finished writing follow the instructions for updating your Cams firmware:Turn on your receiver and ensure it's on a FTA channel.Turn off your receiver.Insert your loader card into your Cam, chip face up, and if not already insert your cam into the receiver.Turn on your receiver.Navigate to the cam menu and choose to load the dragon.After loading is completed follow the instruction to remove your card and switch off your receiver.Turn on your receiver.In the menu you should now see Predator 343.If you have followed these rules and it's still not loading please post back.Best wishesMickha</blockquote>

[QUOTE="Mickha, post: 224601, member: 187442"] Hi noddy_2004, which file are you trying to load onto your Dragon Cam, as there's not a lot left open. To load your cards: PIC F84a, Start your programmer, insert your card, chip face down. From the drop down box choose DragonloaderCard (PIC) Leave the built in loader, and load predator343.dra into ext EEp, choose 2 reverse span and write. For Fun Card 7, Start your programmer, insert your card, chip face down. From the drop down box choose DragonloaderCard (AVR) Leave the built in loader, and load predator343.bin into ext EEp, choose 2 reverse span and write. or Choose PrussianCard5 Load FUN7LDR into flash load predator343.bin into ext EEp, choose 2 reverse span and write. After your card has finished writing follow the instructions for updating your Cams firmware: Turn on your receiver and ensure it's on a FTA channel. Turn off your receiver. Insert your loader card into your Cam, chip face up, and if not already insert your cam into the receiver. Turn on your receiver. Navigate to the cam menu and choose to load the dragon. After loading is completed follow the instruction to remove your card and switch off your receiver. Turn on your receiver. In the menu you should now see Predator 343. If you have followed these rules and it's still not loading please post back. Best wishes Mickha [/QUOTE]

Verification