Reply to thread

Message: <blockquote data-quote="Mickha" data-source="post: 1155783" data-attributes="member: 187442">It's just a matter of trial, and error.Providing you do the basics, a small adjustment on the motor, either up, or down, then adjust your dish, until you peak the signal, on 1W.Before doing anything, make a note, or mark, showing where your dish, and motor, are currently set, and a record of signal quality readings, on the satellites, then compare them, after every adjustment.There was a diagram, somewhere on the site, showing if your dish is too low, or too high, when missing the satellites.</blockquote>