Reply to thread

Message: <blockquote data-quote="Mickha" data-source="post: 1155830" data-attributes="member: 187442">You need the motor, and LNB, set to 0, then either use your receiver to move it East, or West, depending on your Longitude, the required amount, to align it on 1W.If you want to move the motor forward, so that the dish is pointing down, loosen the bottom nut, then tighten the top nut, if you need to raise the motor then loosen the top nut and tighten the lower nut.If you post a picture, of where the nuts are currently, it will help, conversely, if the weather is good, tomorrow, then I will take a picture of my current setup.</blockquote>