Reply to thread

Message

<blockquote data-quote="Vipersan" data-source="post: 846304" data-attributes="member: 325666">Location 53.5N 2.3W..and yes it is very close to running into the mount at full extension (original mount hole)..maybe 2cm of travell left.Still restricted from travelling those 2cm ..even though no longer limit switch restriction needed with jack located in new position...but cannot reach beyond say 55 East.If returned to original mount position ..would have to use limit switch again to stop the jack hitting the mount beyond 62 East.Certainly without the side extension strip on which the motor joint is mounted it would collide with the mount much earlier.Sherical joint to Sperical jointDish due south is 50cmFully closed 11cmpolar axis distance with dish due south ..To joint one jack end 44cmTo joint two ..motor end 38.5cmThese measurements are with the jack located in the recently drilled hole ..not the original mount point hole.rgdsVS</blockquote>

[QUOTE="Vipersan, post: 846304, member: 325666"] Location 53.5N 2.3W ..and yes it is very close to running into the mount at full extension (original mount hole)..maybe 2cm of travell left. Still restricted from travelling those 2cm ..even though no longer limit switch restriction needed with jack located in new position...but cannot reach beyond say 55 East. If returned to original mount position ..would have to use limit switch again to stop the jack hitting the mount beyond 62 East. Certainly without the side extension strip on which the motor joint is mounted it would collide with the mount much earlier. Sherical joint to Sperical joint Dish due south is 50cm Fully closed 11cm polar axis distance with dish due south .. To joint one jack end 44cm To joint two ..motor end 38.5cm These measurements are with the jack located in the recently drilled hole ..not the original mount point hole. rgds VS [/QUOTE]

Verification