Reply to thread

Message

<blockquote data-quote="Lazarus" data-source="post: 846453" data-attributes="member: 323322">Just have a look at the ReadMe file that comes with the repair tool .................... Text reproduced below (The spelling and other errors are not mine!)IIRC, they are correctly set by default, though.Finally, these were written for the F3, but the F5 uses the same Firmware.instrucstionsfirst go to device manager check which port your rs232 is onthen select corosponding port on the programpress upgrade and search pc for the skybox f3 absleave parity has even andbis rate 115200 tick bootloader includepress next make sure the f3 is turned off at the backwhen you have pressed next turn box on at the back you will see com port okthe loader should start loading slowlyif not keep turning the box at the back of and press next then turn reciever on just keep trying till it evently loadsit did take me 4 attenpts before mine connectedand walla all done follow instrustions</blockquote>

[QUOTE="Lazarus, post: 846453, member: 323322"] Just have a look at the ReadMe file that comes with the repair tool .................... Text reproduced below (The spelling and other errors are not mine!) IIRC, they are correctly set by default, though. Finally, these were written for the F3, but the F5 uses the same Firmware. [I]instrucstions first go to device manager check which port your rs232 is on then select corosponding port on the program press upgrade and search pc for the skybox f3 abs leave parity has even and bis rate 115200 tick bootloader include press next make sure the f3 is turned off at the back when you have pressed next turn box on at the back you will see com port ok the loader should start loading slowly if not keep turning the box at the back of and press next then turn reciever on just keep trying till it evently loads it did take me 4 attenpts before mine connected and walla all done follow instrustions[/I] [/QUOTE]

Verification