Advice Needed Jack end bearing

[Manikm909]

ive noticed that the bearing "ring" at the end of my 36" jack has come out - do they just press in? seems an odd one to me.
is this a common fault?

 

[Channel Hopper]

Just Sharing This - Modified my CM LNB holder for KU and CBAND

40.5w coming in ok - need to adjust LNB for ESPN etc....getting fairly strong signal on PASIONES HD (not p0rn) had to raise dish 94 counts....

www.satellites.co.uk

 

[Manikm909]

wrong jack Jack, its the one that drives dish east and west - not up and down.

 

[nelson_b]

ive noticed that the bearing "ring" at the end of my 36" jack has come out - do they just press in? seems an odd one to me.
is this a common fault?

I,v had this happen with - Superjacks - ... if its not damaged , de - grease it and push it back in after applying some superglue :-)

I had one completely break up ... and had to create a replacement using filler paste ....

 

[Channel Hopper]

wrong jack Jack, its the one that drives dish east and west - not up and down.

I didn't mention whch one, the issue is the same, the bearing will loosen and fall out unless certain actuators are under near continuous compression.

 

[Manikm909]

ive managed to press it all back together using some grips - all good, fitted bigger washers too so it shouldnt happen again (he says)