Reply to thread

Message

<blockquote data-quote="Vipersan" data-source="post: 796057" data-attributes="member: 325666">Now I'm back in panic mode ..This time just used Latex on the mould ..let it dry for a full day ..and this evening set about the second panel ...this time with chopped fibre glass re-enforced backing and edging..Just got it complete and was about to carry it outside to let the fumes dissipate for a few hours ..when ..bang ..an almighty thunderclap ..and the heavens opened ..Improvised a bivouac for 90 % of the mould by tipping the entire contents of a recycle bid in the middle of the back yard ..just bottles and plastic ..so should be relatively easy to clean up tomorrow ..Plastic sheet over the bit of mould sticking out ...but inaccessible ..so I can't keep an eye on it..My worry ..that this time using latex only ...it may prove tricker to remove the wing from the mould..particularly as it will be less flexible due to the chopped strand..Doh!!we shall see ..rgdsVS</blockquote>

[QUOTE="Vipersan, post: 796057, member: 325666"] Now I'm back in panic mode .. This time just used Latex on the mould .. let it dry for a full day ..and this evening set about the second panel ...this time with chopped fibre glass re-enforced backing and edging.. Just got it complete and was about to carry it outside to let the fumes dissipate for a few hours ..when ..bang ..an almighty thunderclap ..and the heavens opened .. Improvised a bivouac for 90 % of the mould by tipping the entire contents of a recycle bid in the middle of the back yard .. just bottles and plastic ..so should be relatively easy to clean up tomorrow .. Plastic sheet over the bit of mould sticking out ...but inaccessible ..so I can't keep an eye on it.. My worry .. that this time using latex only ...it may prove tricker to remove the wing from the mould..particularly as it will be less flexible due to the chopped strand.. Doh!! we shall see .. rgds VS [/QUOTE]

Verification