Reply to thread

Message: <blockquote data-quote="a33" data-source="post: 1166715" data-attributes="member: 332642">Did you set the motor angles with motor (at zero) and dish exactly in line?And then found 28E, after using USALS to move to 28E direction, by rotating the whole setup on the mast?Here is a fine-adjustment schematic, for further checking.First check figures 11 and 12 (Notice the arrows of corrected solutions!). If you have done the above method properly, your south-alignment (figures 11/12) should be OK.Then check 13 and 14, for motor elevation/dish declination finetuning.After that, if needed, 11/12 again, and 13/14 again.Greetz,A33</blockquote>