Reply to thread

Message: <blockquote data-quote="D4ftpunk" data-source="post: 1166717" data-attributes="member: 182463">This is interesting, so further extremes of the Arc would have the most error if there was any issue in dis-alignment... That could be in play here. I'll move it to 0 and give it a check in the morning.I did set everything at 0 and exactly in line when setting up. Moved dish to 28E using the receiver USALS command and then adjusted the dish on the motor mount not the pole on the wall. Angle seemed fine, it was the tilt I had to change. I think perhaps that (as per 13/14) may be the thing to tinker with tomorrow.</blockquote>