Reply to thread

Message

<blockquote data-quote="petediscrete" data-source="post: 672067" data-attributes="member: 336641">Hauppauge clearly state their cards don't support other than diseqc 1.0.It appears that it is not advisable to drive a dish motor through the power rail on a PC anyway.I have a Skystar 2 HD card that has a seperate 5 volt molex connector on board but the DBViewer software that comes with it doesn't support disecq 1.2 as it is only a stripped down version of the software.Didn't realise this when I bought the card.In fairness Hauppauge are coming close to developing WinTV 7 as a serious contender in the DVB card/software world.Just waiting for diseqc 1.2 and its complete.A lot of progress made since that awful Powercinema crippleware.I like the sound of the seperate LCD screen so I will go that route and report back.I am using ProgDVB and its probably the best generic DVB software out there.A little unstable when it comes to codecs but best of the bunch</blockquote>

[QUOTE="petediscrete, post: 672067, member: 336641"] Hauppauge clearly state their cards don't support other than diseqc 1.0.It appears that it is not advisable to drive a dish motor through the power rail on a PC anyway.I have a Skystar 2 HD card that has a seperate 5 volt molex connector on board but the DBViewer software that comes with it doesn't support disecq 1.2 as it is only a stripped down version of the software.Didn't realise this when I bought the card.In fairness Hauppauge are coming close to developing WinTV 7 as a serious contender in the DVB card/software world.Just waiting for diseqc 1.2 and its complete.A lot of progress made since that awful Powercinema crippleware. I like the sound of the seperate LCD screen so I will go that route and report back.I am using ProgDVB and its probably the best generic DVB software out there.A little unstable when it comes to codecs but best of the bunch [/QUOTE]

Verification