Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
My Channel Master 1.8 project.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Channel Hopper" data-source="post: 1124975" data-attributes="member: 175144"><p>In post #181 you confirmed they were your 'calculations'.</p><p></p><p>The start and finish points might be acceptable on paper but are entirely impractical in the real world (the choice to ignore the rose joint less so but still a faux pas in polarmount design).</p><p></p><p>It would be somewhat foolish to rely solely on limit switches to prevent an angle where the actuator shaft gets close to the polar bearing point for obvious reasons.</p><p>The additional plate within the o/ps kit might be essential fitment to avoid such a scenario from occurring, the side effect of its inclusion being an inabilty to use one of the shorter actuators on the completed assembly.</p></blockquote><p></p>
[QUOTE="Channel Hopper, post: 1124975, member: 175144"] In post #181 you confirmed they were your 'calculations'. The start and finish points might be acceptable on paper but are entirely impractical in the real world (the choice to ignore the rose joint less so but still a faux pas in polarmount design). It would be somewhat foolish to rely solely on limit switches to prevent an angle where the actuator shaft gets close to the polar bearing point for obvious reasons. The additional plate within the o/ps kit might be essential fitment to avoid such a scenario from occurring, the side effect of its inclusion being an inabilty to use one of the shorter actuators on the completed assembly. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
My Channel Master 1.8 project.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top