Reply to thread

Message

<blockquote data-quote="baleslie" data-source="post: 7915" data-attributes="member: 175199">I have done alot of searching around and I have learned loads of information regarding Irdeto cams but nothing on what I originally set out find out about my own cam.My Irdeto cam has a p/n 901454 and I bought it preprogrammed and I am unable to determine what program is on it.I am unable to get the 3-1 files to work, all I can get is irdeto and betacrypt. I have tried altering the settings in the goodies menu but they do not seem to be the same as every one elses. For a start in the main menu the common interface is shown as irdeto freecam 2 and in the goodies menu I have blocker: mode: and emu: I can only switch mode to &quot;INT&quot; and &quot;GER&quot; and the other two to on and off.The cam does not appear to have been opened so I presume that it was programmed externally so I am also unable to determine what software was on it originally.Can any one tell me if it is possible to load the new freecam 1.07 software on this cam or is it limited to a allcam only.Any help much appreciated.</blockquote>

[QUOTE="baleslie, post: 7915, member: 175199"] I have done alot of searching around and I have learned loads of information regarding Irdeto cams but nothing on what I originally set out find out about my own cam. My Irdeto cam has a p/n 901454 and I bought it preprogrammed and I am unable to determine what program is on it. I am unable to get the 3-1 files to work, all I can get is irdeto and betacrypt. I have tried altering the settings in the goodies menu but they do not seem to be the same as every one elses. For a start in the main menu the common interface is shown as irdeto freecam 2 and in the goodies menu I have blocker: mode: and emu: I can only switch mode to "INT" and "GER" and the other two to on and off. The cam does not appear to have been opened so I presume that it was programmed externally so I am also unable to determine what software was on it originally. Can any one tell me if it is possible to load the new freecam 1.07 software on this cam or is it limited to a allcam only. Any help much appreciated. [/QUOTE]

Verification