Reply to thread

Message

<blockquote data-quote="Trust" data-source="post: 954916" data-attributes="member: 181524">Today spend some time to finish the lnb changer .To attach as many lnb's as possible , the big C horns must be placed at the outside positions , but to pass the F-connector of the TechniRotor (150º move) there must be a long pipe between rotor and spiderhead&nbsp; and a shorter beam . That means , the original CM sidearms are to longs so i used the ones i earlyer made .I send the TechniRotor to &quot;reference&quot; and stored that position for the Ku lnb (BEST twin with Raven feedhorn) so there is always a secure starting point to aligne the dish .Managed to set the KAKUA and C-circ lnb in the most optimum position , still working at the SL3K , if I can replace it with a smaller Ka lnb for 19.2º E , there wil be room for a C-lin lnb .Changed the Ku lnb for the laser lnb , marked the spot on the dish and send the dish to far west and east .The laser spot keeps pointing on the mark , so there&nbsp; was not any deformation from the dish or feedarms .[ATTACH=full]88671[/ATTACH] [ATTACH=full]88672[/ATTACH]</blockquote>

[QUOTE="Trust, post: 954916, member: 181524"] Today spend some time to finish the lnb changer . To attach as many lnb's as possible , the big C horns must be placed at the outside positions , but to pass the F-connector of the TechniRotor (150º move) there must be a long pipe between rotor and spiderhead and a shorter beam . That means , the original CM sidearms are to longs so i used the ones i earlyer made . I send the TechniRotor to "reference" and stored that position for the Ku lnb (BEST twin with Raven feedhorn) so there is always a secure starting point to aligne the dish . Managed to set the KAKUA and C-circ lnb in the most optimum position , still working at the SL3K , if I can replace it with a smaller Ka lnb for 19.2º E , there wil be room for a C-lin lnb . Changed the Ku lnb for the laser lnb , marked the spot on the dish and send the dish to far west and east . The laser spot keeps pointing on the mark , so there was not any deformation from the dish or feedarms . [ATTACH=full]88671[/ATTACH] [ATTACH=full]88672[/ATTACH] [/QUOTE]

Verification