Reply to thread

Message

<blockquote data-quote="Trust" data-source="post: 969469" data-attributes="member: 181524">Both your ways of maeasuring give me doubt .The tapeline from Feedsat can be bended into the the dish , showing a higher pointed spot .Milander shows a spot on a pipe , x mm before&nbsp; the frontline of the dish , showing a (little bit) lower pointed spot .Dont know how Feedsat attached the laser pointer in the lnb holder , but not realy well clamped can lead to mistake .To read the spot on the frontline of the dish , i use a 2 mtr long square boxed alu&nbsp; with a small cardboard glued to the backside .I have a laserpointer in a special made holder exactly fitting in the lnb clamp .The pointer can turn in that holder by a ballbearing , turning it shows some mis alignment , but the middle of that alignment is the centre .The laser transmitter can also set angled to follow the complete edge of the dish[ATTACH=full]92742[/ATTACH]&nbsp; [MEDIA=youtube]CZcesb0G60M[/MEDIA]</blockquote>

[QUOTE="Trust, post: 969469, member: 181524"] Both your ways of maeasuring give me doubt . The tapeline from Feedsat can be bended into the the dish , showing a higher pointed spot . Milander shows a spot on a pipe , x mm before the frontline of the dish , showing a (little bit) lower pointed spot . Dont know how Feedsat attached the laser pointer in the lnb holder , but not realy well clamped can lead to mistake . To read the spot on the frontline of the dish , i use a 2 mtr long square boxed alu with a small cardboard glued to the backside . I have a laserpointer in a special made holder exactly fitting in the lnb clamp . The pointer can turn in that holder by a ballbearing , turning it shows some mis alignment , but the middle of that alignment is the centre . The laser transmitter can also set angled to follow the complete edge of the dish [ATTACH=full]92742[/ATTACH] [MEDIA=youtube]CZcesb0G60M[/MEDIA] [/QUOTE]

Verification