Reply to thread

Message: <blockquote data-quote="william-1" data-source="post: 1098037" data-attributes="member: 193781">No there are still issues with the DiSEqC motor if you switch the power off at the mains the motor will not move to another satellite until I go into DiSEqC 1.2 & select go to position,Then select DiSEqC 1.3 USALS & after a bit of prompting the motor commands are restored to the SX88-4K.If you leave the receiver on standby the motor will respond when you re-start the SX88-4K,There is another problem that has come to light with the SX88-4K,When I use the remote extension the light remains green on standby ? But with the SX88+ on standby the remote extension turns to red the same as the receiver.</blockquote>