Reply to thread

Message

<blockquote data-quote="jeallen01" data-source="post: 1060571" data-attributes="member: 176704">Many thanks but still not sure what your config is or would be (Rx-&gt; Switch -&gt; Motor OR Rx-&gt; Motor-&gt; Switch)?I have an EMP 2-way switch of a type (S2_1PCN-W1) that I know will pass on DiSEqC 1.1 &amp; 1.2 (&amp; hopefully also 1.3/USALS) commands, and that would be at the Rx end of various cables running down the garden, as well as a Opticum 10-1 switch (which doesn't pass on the commands), and a cable TD88/Superior Dark Motor on one of the poles (and ignoring the TD110 which is on its own cable).I'd like to use the EMP switch to switch between the 2 cables to the TD88 and the Opticum, and then set up the 10 i/ps to the Opticum with cables from the fixed dishes (now reinstalled but not aligned, after the &quot;potenial neighbour&quot; issues a few months ago!) - thus the EMP switch would select either the motor and pass on 1.3/USALS commands to it, or the Opticum under DiSEqC 1.0 and then pass the DiSEqC 1.1 commands to itto select the appropriate fixed dish LNB - obviously the USALS would be switched off in the Rx for those LNBs.Does that make sense/seem viable?</blockquote>

[QUOTE="jeallen01, post: 1060571, member: 176704"] Many thanks but still not sure what your config is or would be (Rx-> Switch -> Motor OR Rx-> Motor-> Switch)? I have an EMP 2-way switch of a type (S2_1PCN-W1) that I know will pass on DiSEqC 1.1 & 1.2 (& hopefully also 1.3/USALS) commands, and that would be at the Rx end of various cables running down the garden, as well as a Opticum 10-1 switch (which doesn't pass on the commands), and a cable TD88/Superior Dark Motor on one of the poles (and ignoring the TD110 which is on its own cable). I'd like to use the EMP switch to switch between the 2 cables to the TD88 and the Opticum, and then set up the 10 i/ps to the Opticum with cables from the fixed dishes (now reinstalled but not aligned, after the "potenial neighbour" issues a few months ago!) - thus the EMP switch would select either the motor and pass on 1.3/USALS commands to it, or the Opticum under DiSEqC 1.0 and then pass the DiSEqC 1.1 commands to itto select the appropriate fixed dish LNB - obviously the USALS would be switched off in the Rx for those LNBs. Does that make sense/seem viable? [/QUOTE]

Verification