Reply to thread

Message: <blockquote data-quote="jeallen01" data-source="post: 1087170" data-attributes="member: 176704">That implies that that the dish is "looking" slightly below sat when at 30W and probably the same at 28.2E when the arm has been lifted that little bitIt would suggest  that you need to very slightly nudge the motor a tad to the West on the pole, but with the dish arm in its original position and not raised that 2mm - that would then raise the dish beam a little at 30W, and thus get the channels on there,and lower it a little at 28.2E, which shouldn't matter as most of the channels there are very strong.It should also help all with most of the sats in between as the dish should then be tracking the arc rather better.</blockquote>