Reply to thread

Message: <blockquote data-quote="Vipersan" data-source="post: 807860" data-attributes="member: 325666">..not quite sure why this would be a problem ..as far as adjusting the focal point CJ ..since the feed you are joining to would be already at the optimum focal point ..obviously if the feed itself is anchored rigidly then you wont be able to rotate the whole assembly when the the cut n shut is done ...and as such you'd have to be accurate when setting the lnb position and joining it to the feed ..ie vertical at true south ..on a motorised or fixed dish ..If however the feed is simply clamped at the focus and is free to rotate when when the clamp is slackened off ..then there would be no problems tweaking the skew..rgdsVS</blockquote>