Reply to thread

Message

<blockquote data-quote="Manikm909" data-source="post: 1149946" data-attributes="member: 415764">thanks!another question, is it possible to alter just one of the Azimuth software limits without having to go through setting ALL 4 positions (those being Azimuth East and THEN West and THEN Elevation DOWN and UP) i.e lets say i thought i was at 55w but i was only at 47.5w when i set WEST limit - can i just extend this WEST side limit without having to drive dish all the way to the EAST to set that and then back again?There doesnt seem to be a skip button - to allow changing just that one limit settingI cant see where you can turn off H and V polarity when storing a sat - it forces it, have to select H and V even with Polaritor = 0 in CONFIG .&nbsp; When you chose a sat, you have to pick the sat, followed by either V or H (which are the same for m)</blockquote>

[QUOTE="Manikm909, post: 1149946, member: 415764"] thanks! another question, is it possible to alter just [B]one[/B] of the Azimuth software limits [B]without [/B]having to go through setting [B]ALL[/B] 4 positions (those being Azimuth [B]East [/B]and THEN [B]West [/B]and THEN Elevation [B]DOWN [/B]and [B]UP) [/B] i.e lets say i thought i was at 55w but i was only at 47.5w when i set WEST limit - can i just extend this WEST side limit [B]without[/B] having to drive dish all the way to the EAST to set that and then back again? There doesnt seem to be a skip button - to allow changing just that one limit setting I cant see where you can turn off H and V polarity when storing a sat - it forces it, have to select H and V even with Polaritor = 0 in CONFIG . When you chose a sat, you have to pick the sat, followed by either V or H (which are the same for m) [/QUOTE]

Verification