Reply to thread

Message: <blockquote data-quote="ArloG" data-source="post: 1167231" data-attributes="member: 418555">From what I see in the manual it is stated the motor output voltages are 36 volts. And regulated at the H-bridge FET circuit. I do see a couple of variable resistors that perhaps could be adjusted for voltage. The manual also covers voltage regulation for motor direction.It is kind of stressed, since these are industrial units, that AC drive motors and hard contact reversing controllers are common.There is a section advising dropping resistors on the motor outputs to use 24 VDC relays that then control positioning motors.In the RC2000 manual I didn't see the power supply sections. It may have been an older document.</blockquote>