Reply to thread

Message: <blockquote data-quote="s-band" data-source="post: 990885" data-attributes="member: 407744">After finishing the 1.8 & 3.8 maybe and if you build the Seavey style rotator!I presume that the software is present in all models, would you like to see if you can access the controls? It looks like it just has to be enabled in the expert mode. I presume the control pins on the connector (C4, 5 & 6) will toggle if you operate the controller or waggle the pot feedback voltage. I suppose that it may get the hump if there is no voltage fed back from the pot. Most of the bits are RS\Farnell\Mouser etc. I don't think that the regulators, VR1 & 2 are needed if your rotator runs from 12V.</blockquote>