Reply to thread

Message

<blockquote data-quote="mikeey" data-source="post: 12643" data-attributes="member: 175127">here are instructions on how to read and edit funcards/silvercards using picpined edit......I did it and it works...when you get a new key instead of reprogramming entire card you can simply edit the one key(usually an irdeto key) In picpined you get the option to programme only any changes you make...here goes...down load picbind set it to your com port lowest baud rate remove tick from smart mouse and sat to phionix mode insert card choose ds9 5in1 ect do the same at the other side sometimes it will do this auto press read card picbind will read go to keys and scroll down and pick the code you whant to change write in new code go back to phionix mode press write card done hope this helps.....this I got from a forum, but the following are the setting I used to make it all work...port 1firmware ds9/c64&gt;&gt;allcaminterface phoenixDelay 1 all eprom databaudrate 5726&nbsp; &nbsp; index 0000parity even&nbsp; &nbsp; &nbsp; length 2000stop bits 2&nbsp; &nbsp; &nbsp; secret key 0000data bits 8&nbsp; &nbsp; smartmouse disabled&nbsp;&nbsp; fast write disabled....remember to plug in your old Phoenix/smartmouse to read eprom!!!!!Rolf is this any good,if you all ready have just delete itregards mikeey</blockquote>

[QUOTE="mikeey, post: 12643, member: 175127"] here are instructions on how to read and edit funcards/silvercards using picpined edit......I did it and it works...when you get a new key instead of reprogramming entire card you can simply edit the one key(usually an irdeto key) In picpined you get the option to programme only any changes you make...here goes... down load picbind set it to your com port lowest baud rate remove tick from smart mouse and sat to phionix mode insert card choose ds9 5in1 ect do the same at the other side sometimes it will do this auto press read card picbind will read go to keys and scroll down and pick the code you whant to change write in new code go back to phionix mode press write card done hope this helps.....this I got from a forum, but the following are the setting I used to make it all work... port 1 firmware ds9/c64>>allcam interface phoenix Delay 1 all eprom data baudrate 5726 index 0000 parity even length 2000 stop bits 2 secret key 0000 data bits 8 smartmouse disabled fast write disabled....remember to plug in your old Phoenix/smartmouse to read eprom!!!!! Rolf is this any good, if you all ready have just delete it regards mikeey [/QUOTE]

Verification