Reply to thread

Message

<blockquote data-quote="a33" data-source="post: 1080770" data-attributes="member: 332642">I don't see it being advantageous, an upside down dish here.The bottom of the dish is near the pole, with 'normal' dish position.When upside down, the new 'bottom' position is further from the pole, and must therefore be HIGHER, to be in the bottom edge of the beam!For upside down dish placement advantadges, I learned to think primarily in visualisations of the BEAM, and how you can place a dish in that beam. My conclusion is that upside down placement is advantageous in only very few situations.(See e.g. (my post on) a german forum: <a href="https://forum.digitalfernsehen.de/threads/offsetspiegel-hinter-balkongel%C3%A4nder-verstecken.408514/page-2#post-8644012" target="_blank">Offsetspiegel hinter Balkongeländer verstecken</a>&nbsp;&nbsp; )What would make a difference for pole height, is if the arm of the motor is above, or under the motor (STAB motor versus SG2100 motor).But the dish hight would still need to be the same; so it would just affect the pole height a bit.Greetz,A33</blockquote>

[QUOTE="a33, post: 1080770, member: 332642"] I don't see it being advantageous, an upside down dish here. The bottom of the dish is near the pole, with 'normal' dish position. When upside down, the new 'bottom' position is further from the pole, and must therefore be HIGHER, to be in the bottom edge of the beam! For upside down dish placement advantadges, I learned [B]to think primarily in visualisations of the BEAM, and how you can place a dish in that beam[/B]. My conclusion is that upside down placement is advantageous in only very few situations. (See e.g. (my post on) a german forum: [URL='https://forum.digitalfernsehen.de/threads/offsetspiegel-hinter-balkongel%C3%A4nder-verstecken.408514/page-2#post-8644012']Offsetspiegel hinter Balkongeländer verstecken[/URL] ) What would make a difference for pole height, is if the arm of the motor is above, or under the motor (STAB motor versus SG2100 motor). But the dish hight would still need to be the same; so it would just affect the pole height a bit. Greetz, A33 [/QUOTE]

Verification