Reply to thread

Message

<blockquote data-quote="Vipersan" data-source="post: 985534" data-attributes="member: 325666">Well ..certainly the whole system seems more stable now ...not had any crashes with the new card ..but ..sadly the problems are still there ..Basically ..I start everything up ..one dongle at a time ...then start the jaeros one at a time ..then start plane plotter ..planes start appearing ...and this builds.I check back periodically ...and eventually there comes a point where there are no planes on pp ....data is still flowing ...but jaeros report no tracking data ...just a long list of Bad RT packets ..Looking at the SDR# screens clearly show that the vfos are on frequency ...there are data packets in evidence ...but jaero doesn't 'decode' anything useable.So ..I stop each sdr# ..then start them again one at a time.Not closing them down ..just hitting stop ..then start ..Slowly planes start to appear again on PP ..fwiw ..This is either an SDR# issue ...or virtual cable issue ...or possibly an internal pc hardware issue ...This is a new build so I can't blame the previous installation ..but the same software has been installed of course.I shall try this again with just a single vfo per SDR # active in case this is the cause ..have you seen anything similar confucian ?</blockquote>

[QUOTE="Vipersan, post: 985534, member: 325666"] Well .. certainly the whole system seems more stable now ...not had any crashes with the new card .. but ..sadly the problems are still there .. Basically .. I start everything up ..one dongle at a time ... then start the jaeros one at a time .. then start plane plotter .. planes start appearing ...and this builds. I check back periodically ...and eventually there comes a point where there are no planes on pp .... data is still flowing ...but jaeros report no tracking data ...just a long list of Bad RT packets .. Looking at the SDR# screens clearly show that the vfos are on frequency ...there are data packets in evidence ...but jaero doesn't 'decode' anything useable. So ..I stop each sdr# ..then start them again one at a time. Not closing them down ..just hitting stop ..then start .. Slowly planes start to appear again on PP .. fwiw .. This is either an SDR# issue ...or virtual cable issue ...or possibly an internal pc hardware issue ... This is a new build so I can't blame the previous installation ..but the same software has been installed of course. I shall try this again with just a single vfo per SDR # active in case this is the cause .. have you seen anything similar confucian ? [/QUOTE]

Verification