Reply to thread

Message

<blockquote data-quote="a33" data-source="post: 1040216" data-attributes="member: 332642">(That would be a diseqc command. USALS is just the software part in the receiver that calculates from site latitude and longitude and satellite longitude to the needed &quot;Hour Angle&quot;, needed for the diseqc GotoX command, as I understand it all.)I thought about that too, as a &quot;solution&quot;. The weird symptom isn't explained by that, though.Is it because the limit switch elicits a motor stop command, a reset command, or something else? By the receiver, or by the motor itself?And were the sent motor commands really identical?You'd need a diseqc command reader, to test this, at the receiver/satellite-finder end.Was no LNB attached to the motor, while testing? That could have had an effect, too.Would it be possible to think of a testing setup (modifying the motor), where the symptom could switch to the other limitswitch? Which would make it clear that is really is a motor problem, not a receiver problem?I wish the paypall complaint committee lots of wisdom.....greetz,A33</blockquote>

[QUOTE="a33, post: 1040216, member: 332642"] (That would be a [B]diseqc[/B] command. [B]USALS[/B] is just the software part in the receiver that calculates from site latitude and longitude and satellite longitude to the needed "Hour Angle", needed for the diseqc GotoX command, as I understand it all.) I thought about that too, as a "solution". The weird symptom isn't explained by that, though. Is it because the limit switch elicits a motor stop command, a reset command, or something else? By the receiver, or by the motor itself? And were the sent motor commands really identical? You'd need a diseqc command reader, to test this, at the receiver/satellite-finder end. Was no LNB attached to the motor, while testing? That could have had an effect, too. Would it be possible to think of a testing setup (modifying the motor), where the symptom could switch to the other limitswitch? Which would make it clear that is really is a motor problem, not a receiver problem? I wish the paypall complaint committee lots of wisdom..... greetz, A33 [/QUOTE]

Verification