Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Usals problem & alignment
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Channel Hopper" data-source="post: 1085183" data-attributes="member: 175144"><p>Ha, I was right. <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite62" alt=":-wow" title="Wow :-wow" loading="lazy" data-shortname=":-wow" /> <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite63" alt=":-smallmam" title="Mamster Small :-smallmam" loading="lazy" data-shortname=":-smallmam" /><img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite63" alt=":-smallmam" title="Mamster Small :-smallmam" loading="lazy" data-shortname=":-smallmam" /><img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite63" alt=":-smallmam" title="Mamster Small :-smallmam" loading="lazy" data-shortname=":-smallmam" /><img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite64" alt=":-mamster" title="Mamster :-mamster" loading="lazy" data-shortname=":-mamster" /><img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite63" alt=":-smallmam" title="Mamster Small :-smallmam" loading="lazy" data-shortname=":-smallmam" /><img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite63" alt=":-smallmam" title="Mamster Small :-smallmam" loading="lazy" data-shortname=":-smallmam" /><img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite63" alt=":-smallmam" title="Mamster Small :-smallmam" loading="lazy" data-shortname=":-smallmam" /></p><p></p><p>Pictures later this afternoon (it started raining a few minutes back) but the important parameter is not the elevation of the satellite, but the of the reflecting part of the dish that can clear any obstacle in between.</p><p></p><p>I have installed the Gibertini here, an old design of 1m, the elevation bracket design does not allow inversion, since the bolt grooves on the lower locking bolt allow about 40 degrees of movement, not the 55 that would normally be required to reverse it on the pole. If the mechanism had been offset by about 20 degrees from dead vertical then it might be feasible.</p><p></p><p>I have therefore propped the dish into the position to allow inverted reception, just clearing a shed opposite in the direction of Hotbird, and the measured difference in height to ensure the same signal is a little over 15.5 cms , or 6 inches in old money.</p><p></p><p>I made an error in the first measurement by taking the lowest height at the top of the boom arm as well, the effective reflector surface is a good 2cms higher than this , though a little further forward, so I believe it can be dismissed.</p></blockquote><p></p>
[QUOTE="Channel Hopper, post: 1085183, member: 175144"] Ha, I was right. :-wow :-smallmam:-smallmam:-smallmam:-mamster:-smallmam:-smallmam:-smallmam Pictures later this afternoon (it started raining a few minutes back) but the important parameter is not the elevation of the satellite, but the of the reflecting part of the dish that can clear any obstacle in between. I have installed the Gibertini here, an old design of 1m, the elevation bracket design does not allow inversion, since the bolt grooves on the lower locking bolt allow about 40 degrees of movement, not the 55 that would normally be required to reverse it on the pole. If the mechanism had been offset by about 20 degrees from dead vertical then it might be feasible. I have therefore propped the dish into the position to allow inverted reception, just clearing a shed opposite in the direction of Hotbird, and the measured difference in height to ensure the same signal is a little over 15.5 cms , or 6 inches in old money. I made an error in the first measurement by taking the lowest height at the top of the boom arm as well, the effective reflector surface is a good 2cms higher than this , though a little further forward, so I believe it can be dismissed. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Usals problem & alignment
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top